Bluetooth Speaker

iPhone

  1. Power On the speaker by pressing and holding the Power button for 2-3 seconds in the top. 
  2. Once the speaker has been Powered On, open the Settings app on your iPhone.
  3. Click on Bluetooth. 
  4. Under OTHER DEVICES at the bottom, click M10 or M13. 
  5. You should now be connected. 
  6. Power Off the speaker by pressing and holding the top button for 2-3 seconds. 

Android

  1. Power On the speaker by pressing and holding the Power button for 2-3 seconds on the top.
  2. Once the speaker has been Powered On, swipe down from the top of your phone screen. 
  3. Touch and Hold Bluetooth. 
  4. Click Pair new device. If you don’t find Pair new device, check under “Available devices” or tap More. Refresh.
  5. Click on M10 or M13. 
  6. Follow any on-screen instructions. 
  7. Power Off the speaker by pressing and holding the top button for 2-3 seconds. 

Dropped in the Sand

The speaker is supposed to be sand proof but please follow the steps below just so we can keep them in good working order. 

  1. Do not use your finger, keys or other object to try to get the sand out of the top as it could push it into further into the speaker. 
  2. Turn it upside and and play a song with a lot of bass in it while shaking it out.
  3. Most, if not all the sand will come out and you are good to go. 

Adjusting the Sound

  • Click the EQ button to toggle through different sound modes. 

Adjusting the Lights

  • Click the Power button once to change colors. 
  • Double click the Power button to turn off the light (this will conserve the battery).

Two Speaker Pairing

  1. Follow the instructions above for your iPhone or Android to Power on and then to connect to one of the speakers.
  2. Once the one speaker is powered on and paired with your phone, power on the other speaker.
  3. Determine which speakers you have:
    1. If you connected to the M13 speakers then double-click the button that looks like a figure 8 button on the speaker you just powered on (You will hear one prompt sound).
    2. If you connected to the M10 speakers then double-click the EQ button on the speaker you just powered on.
  4. The speakers are now paired.